|
Southeastern Kansas | I think this is the way to adjust the concave from the front to the back. The cylinder rasp bar should touch the second or third bar on the front of the .concave. Do this to both sides. . Then find the little hole with a slide up door on the side of the machine toward the back of the concave. The distance from rasp bar to concave should be 3/8". Do this to both sides. That seems to be how it was done if I remember correctly. Also had a neighbor with a 3300 JD cutting beans last year when his chopper belt came off. Straw walkers kept cramming it to the back of the machine until the slip clutch gave on the walkers. He took the back top sheet off the machine and rolled out the bean residue. It looked like a round hay bale. I went home and checked to make sure my chopper wires were hooked up properly. | |
|
Two initiations into the Combine Operator Club
