|
Ilderton, Ontario | thanks for the reply Ted. The controls are on a RedBall tender built by Montag. The valve is a PWM. I have this setting selected on the controller. I think I may have found the culprit, but you may help varify this. I am suspecting the speed sensor on the feed roll motor. I have voltage to the sensor, but no out put from the sensor while the motor is turning. If the controller isn't being told the speed of the motor this would explain why the INC/DEC switch won't control the motor since it isn't getting any information as to speed. Does this make any sense? | |
|
Raven 660 help!
