|
| there is a groove around the outside of the housing that lines up with the grease holes in bushing. so it doesnt matter where the holes are, as long as the bushing is centered. the grease usually cakes up that it will not let any new grease flow thru. jack up on the frame to take pressure off and see how badly bushing is wore. if it not too badly worn, then maybe with the pressure off you can force some new grease thru. if that dont work, take a torch and warm up the housing. not hot just warm. this will soften the old grease and allow it to be pushed out. i also recomend using non-clay based grease so it will not cake up again. power grease guns help too. they have more pressure to force the grease. | |
|
front axle pivot 4430
