|
| Hey Trimbleguy, I have done a few more roll cals...I'm all within an inch but I'd say it's very inconsistent. I did notice I am getting a message saying no IMU found in one of the settings menus. I'll post the picture. Do I have a bad IMU in the NAV??
And I am not getting a GPS feed to the PRO1200. I will get GPS to the 1200 if I use the factory roof harness that came with the novatel receiver and plug it into the nav900. But then theGFX won't engage. If I use the Trimble harness which is only a 2 wire harness on the 12 pin connection I will lose GPS to the 1200 but the 1260 will work then.
Side note...also going in reverse while engaged the wheels make a full turn and then try to straighten out. But does not hold line very good at all while in reverse. It'll definitely run over the crop. So lots of little things going on which makes me wonder about the NAV.
Thanks
Edited by mpanowicz123 2/28/2024 21:01
(20240227_085223 (full).jpg)
(20240227_085215 (full).jpg)
Attachments ---------------- 20240227_085223 (full).jpg (64KB - 18 downloads) 20240227_085215 (full).jpg (70KB - 24 downloads)
| |
|