|
| I have done a few roll cals...I wouldn't say I'm happy with it. It's been rather difficult. Id say I'm within an inch. But when I'm calibrating I stop to where the offline distance is flickering left and right then get out and set my blocks with flags against the sway blocks in the back. Then I get back in the cab and it'll say I'm off an inch or so. It doesn't stay consistent. I can't find a deadband cal...id assume thats all done in the auto cal?
And the AB lines were transferred into a USB from FMX directly to the GFX. I know sms will convert them too but the GFX took them right in.
I should also mention this is on an AFS connect Magnum with a pro 1200
Edited by mpanowicz123 2/26/2024 15:40
| |
|
Trimble FMX to a Trimble GFX1260
