|
NoDak | A New Leader splitter cable must be used to get the signal split between the GreenStar display and an Ag Leader touchscreen display. Part Number for this cable is 302348 and can be ordered from a John Deere SprayStar Dealer. This cable splits the signal at the StarFire receiver and allows the factory system to continue to be used as intended. The other half of the cable will send signal to the Ag Leader console.
The GreenStar display must be powered up and operational for the StarFire GPS receiver to work.
Configure the GreenStar Display and StarFire Receiver to Output GPS
The following steps must be followed in order to configure the GreenStar display and StarFire receiver to send signal to the Ag Leader display:
Power the GreenStar monitor on. (Usually by turning the key on)
Acknowledge the warning
Press the Setup button
Press the StarFire / StarFire ITC button
Press the Serial RS232 Output button
Set Baud rate for your application (4800, 19200, 38400)
Set output rate for your application (1Hz or 5Hz)
Turn GGA and VTG messages on. All other strings should be turned off
When using an Ag Leader autosteer controller disable TCM in the GreenStar
At this point the StarFire receiver is configured to output GPS to both the GreenStar monitor and the Ag Leader display. | |
|
SF6000 to Ag Leader Integra
