|
SE Nebraska | New to me nh3 machine has fast valve raven. Also has three section control. Of the wires that went to the fast valve the green and yellow should go to the new servo. The white and orange will be ground and power and the blue with white stripe will be trigger for shut off valve. On ag leader liquid control module end the blue wire with white stripe is taped off. I am thinking it goes to pin 6 on boom plug. Is this all correct?
Also how is this handled in the monitor? Boom 1,2,3 will have a boom width. But boom 6 controls the on off so will it work without a width? I haven't got the Integra hooked up at this point yet so I'm still guessing.
Edited by Todd P 1/28/2024 15:54
 (IMG_20240127_181856199 (full).jpg)
 (IMG_20240127_181921072 (full).jpg)
 (IMG_20240126_170317845~2 (full).jpg)
Attachments
----------------
 IMG_20240127_181856199 (full).jpg (153KB - 34 downloads)
IMG_20240127_181921072 (full).jpg (117KB - 36 downloads)
IMG_20240126_170317845~2 (full).jpg (159KB - 34 downloads)
| |
|
Raven fast valve to two valve conversion.
