|
Olivia, MN | MAGNUM Countryside 3500P Multi-Fuel Corn Wood Pellet Stove Furnace installed in shop: Running wood pellets, but auger keeps sliding out of the motor shaft. Had the unit mostly apart and it doesn't seem to have a pin or anything to hold the shaft into the motor shaft union joint. Any ideas? I am thinking of trying to weld a small washer on the outside of the auger feed to keep the shaft from spinning out to far from the internal auger shaft union joint but it sure would be a pain if i needed to take apart again.
 (Firepot and Auger for 3500 (full).jpg)
Attachments
----------------
 Firepot and Auger for 3500 (full).jpg (33KB - 75 downloads)
| |
|
Countryside Magnum 3500 Dual Fuel pellet stove Auger issues
