Near Intersection of I-35 & I-90 Southern Mn. | IH PULLER - 11/20/2023 18:07
I have a new 660 I bought for a project and went a different route. I would sell very reasonably don’t need it just laying on the shelf
The 660 could work fine for this but it normally does not contain a built in Master or section switches. It would be easy to work around that though. One method would be add a couple of wires to the display harness and a switch. The wires would splice on to a 12V source such as the red wire and the section 1 wire which is the black wire.
When that switch is ON, 12V would be fed to the black wire which informs the display that Section 1 is ON so it can do it calculations properly and provides 12V out to the bar where it may be needed. |
Raven 440 nh3 monitor- what newer model replaces it ??
