|
Northwest Iowa | It is like the bale is too big for the processor. The bale sits on top of the 2 square turning rollers that should push it into the knives but they don’t. I even pushed on the bale with the loader to make it feed and it didn’t. I tried turning the rollers the opposite way and rotating them each direction since they are hydraulic. No luck. Once the bale is loose inside it just rides on top. I spent almost a hour to get this bale out. Taking it back to the implement in the am. There are easier ways to torture yourself!!
 (IMG_1810 (full).jpeg)
 (IMG_1812 (full).jpeg)
Attachments
----------------
 IMG_1810 (full).jpeg (195KB - 80 downloads)
IMG_1812 (full).jpeg (173KB - 82 downloads)
| |
|
Degelman Bale King 3000 bale processor problems.
