|
NE IA | Material may be a little short, but IMO degelman has their rotators just a little to wide so as bale size decreases they can setup just as you have experienced. About all you can do is lower the bar or fineness of cut adjuster to help keep bale spinning and when you get to that bale size keep it spinning fast and finish off the bale. I have a Highline same as vermeer and you can move rotators in on it to help get away from that problem. My brother has a degelman and we have discussed this very thing. But it can happen on all of them if bales get mushy or are to soft to start with or short material. | |
|
Degelman Bale King 3000 bale processor problems.
