| cmetzg - 1/25/2023 07:30
Ok, thanks for the info! I’m guessing that I just need to turn that output on. I wondered if that could be the case, but I had been through all the settings and the manual and didn’t see anything obvious.
Can you share the actual command that needs to be sent, or should I contact a dealer?
I figured that I’d need to adjust the speed cal # in the Raven, I was just surprised to have no signal.
Enter these two commands:
RADARCONFIG ENABLE 36.11 5Hz 500 5
SAVECONFIG
FWIW, Radar Speed output should be enabled by default.
You could try to "Reset to Defaults" from the GPS setup menu, that would also enable it.
Edited by redpower 1/31/2023 08:12
|