|
North Dakota | Later versions of firmware should not have that problem. If you have version 30 or earlier go to the toolbox and find the boom configuration, make sure fencerows do not have a checkmark. There was a problem with the early versions that would not do the math correct if fencerows were selected.
Make sure the speed is correct on the 700, there is a calibration for the speed. I drive a speed according to the GPS and set the cal number so it matches.
For the gallons, if you fill the tank until it is full to the top it holds about 1030 gallons, check that the gallons used match the tank. That would be a flowmeter cal. The Raven website has a small spreadsheet to calculate the correct flowmeter cal number. | |
|