|
Sioux Center, Iowa | www.kooima.com did make processors to put on pulltypes. Not sure if they actually had one to go on the 881 though. I looked at their latest listings and don't actually see the processor kits listed anymore. The units I remember them having were $5000. I know a couple people that put them on NH and JD units with good results. We added a NH processor to a NH 900 and like it. You should be able to find a NH900 with a processor on it and a 3rn head for quite a bit less than $30,000. I think you could almost get a FP240 and 3rn head for that by now. We run a 7140 on the 900 and if you use all 200 hp, the processor rolls chatter from too much crop going through.
There were a couple other companies that made add on processors but I can't recall the names.
A quick look on tractorhouse will give you a good idea what's available for cutters. | |
|