|
| Thanks Jim, I found Moores web site and they certainly do look heavy duty.
So, let's say I get a Moore Built tool bar. If I want the front coulter to run shallower, do I just tip the front of the tool bar up a little? Thanks.
This may not be your expertise, Jim, but would a 2+2 IH tractor be a good choice to handle a strip till rig with a 3 pt Moore Built toolbar? It looks like they would have plenty of front weight on the tractor. I have never driven one. When you steer them, does it feel like the whole tractor is jerking (like a 4x4 tractor) or are they smoother steering because you sit behind the pivot point, rather than sittingin front of the pivot point like most 4x4 tractors. I sure don't need any more horse power, or traction, the Case 2390 had plenty of that. | |
|
Anyone else used a cyclo tool bar for Dawn Strip till set up?
