|
Osnabrock ND | What you do is on the right side of tranny take off linkage [2 of them] and remove cover. Make sure you mark where the arms and shafts are. Cuz you take out a roll pin and have to have it in the right position. On mine I removed roll pin and had to press out the shaft. It was unreal that it even still shifted but it did. Cleaned up shafts and antiseized them all up put back together and works like a charm. It was unreal how tight the shaft was in the cover. Took about a little over an hour and done. Hope this help, it sure did for me.
jeff | |
|