|
| I replaced one once with a new steel factory line - it was a tough job but I don't think I had to loosen or take off any of the other lines. Probably be a good idea to have the new one on hand before you take out the old one so you don't forget what twists and turns it took to get it out of there. May seem dumb but sometimes writing a couple notes as you take it off might help remembering what it takes to put the new one on. Might give yourself a little more room by taking the breakaway right off and replace it after the line is in. Good luck.
| |
|
Case 90 series hydraulic lines under cab?
