|
| Most ball valves have 3 wires coming out of them. One is 12 hot, one is 12 volt switched from the control switches and the third is ground. A 2 wire valve may be using an internal case ground so there are only 2 wires. Your controller should work fine with either system as long as it is wired properly.
I have attached pics of a remote control unit I built to control the valves for tip cleaning and inspection. I have found it to be very a useful tool.
INDY
Edited by Indianajones 2/4/2009 18:09
(P1010005 [50%].JPG)
(P1010002 [50%].JPG)
(transmitter (2) [50%].JPG)
Attachments ---------------- P1010005 [50%].JPG (52KB - 62 downloads) P1010002 [50%].JPG (60KB - 56 downloads) transmitter (2) [50%].JPG (35KB - 59 downloads)
| |
|