In advanced mode: Press OK to reset guidance and start or select a field Select the stored field -> Create a new event or use the same -> OK -> OK -> Then change Implement Setup

Other way: Just add an AB line to the field which is open. Select A+ and change Implement setup. Then you have to press OK for setting the A point. Direction is the same as the last AB you have created or selected in the field. A+ is not working in curve mode, of course.

In Easy Mode: Just add a new AB line and select A+ pattern and change the implement width. It is quite the same as in advanced mode.

If you want to read the heading towards the tractor is facing, press button I two times and you can read out the heading. North is 0°, East 90° and so on...

What I want to see in the next Firmware is a simple mapping function (point mapping) similar to FMD. Maybe someone from Trimble guys is reading this request.