|
Bonanza, Or | I have a problem with my Ez 500 on XP and Ez steer that was working just fine last night when I shut down.
I am running in the pivot mode, made my original A B line on the outside tower wheel track. I worked the ground starting at the outside and worked my way in, I then started drilling on the inside working my way out because of the side draft of the cultimulcher-drill combo.
Last night it was following the line right on the money but today when I fired it up it thinks the pivot is some odd shape and only one place is it on line, other places it may want to cross over 2 or more lines where you have already been.. I tried re converging...no change, stopped and did a fast restart...... no change, tried putting in a new A B and it does the same thing.
From what I have been told it is acting like the nudge button was hit in the pivot mode but I know that didn't happen.
This field is really flat and I am running at 6 MPH.
Only thing I haven't done is to recalibrate the T2.
Any Ideas? | |
|
EZ Guide 500 and Ez Steer problem
