|
Alma NE | I run a 9760sts
it has the electric sieves and chaffer the buttons and the switches out side will open and close the sieve and chaffer but the numbers in the cab don't move the chaffer is stuck on 16 and the sieve is stuck on 4
i took them both out of the machine cleaned them up really good and made sure the electrical connections are good and clean
i calibrate the sieve and it calibrates ok but still the numbers don't move i can hear the motor running and have watched it open and close no problem
when i try to calibrate the chaffer i can hear the motor run it opens and closes then stops and the screen says hold and wont move off hold unless i abort the calibration
i can run the combine but i have to set the opening width of the sieve and the chaffer by using a bolt for a measurement
Do you have any idea what might be going on?
thx for any help
Nick
Edited by deeredriver 9/24/2008 22:41
| |
|
Question for ststech
