|
Callao Missouri | http://www.bolingmachine.com/
Check out these guys. I put a lot of thier seals in. I never use the deere junk seals that they try to sell over the parts counter.
You need to order a new shaft, Bushings, and Seal bushings from Boling's Order a shim assortment from Deere so you can tighten that raskal down.
Driveing out the old bushings takes some skill you have to drive them out from the oppicat side. Takes a 24" or so punch. Be carefull not to bust a chunk of the transmission houseing out doing this but once you get your punch set have someone hold it in place with a pry bar and annother beat hell out of the other end. Remember a couple smacks here then put the punch 180* from there and do it again. Jon | |
|
4020 Load control shaft seal ???'s
