|
| Well actually a question on the ones that WON"T take grease. If I remember right those zerks don't come out or if they do another won't go in to stay. How do you get these freed up other than replacing the whole assembly? Tried the grease buster thing but no luck. Put a little heat around the zerk area but no help. Have 3 that are stuck but only tried one with the heat. Figured I was going to burn the seals out so stopped that. This disk was under water for a few hours so think it might be important to flush good with grease. Any help? Thanks Don | |
|
Greasing gang bearings on IH 490 disk???
