Hi all. Many thanks to all that helped with the math questions I asked a while back. Special thanks to dko for the drawing which resulted in the needed measurements. Thread.     Drawing link.

 Here's a few pics of where the project is today. Its about 100 degrees out right now so I quit for the afternoon and will go back to work on the combine maybe later this evening when it cools a bit. Most of the pics are self explaining so I'll upload directly here with no captions since I dont know how to use this sites editor yet. Usually I use photobucket and can insert an explaination, but photobucket is having issues again so......

 Hopefully just a little touchup work with the grinder and I can get the boss's son to throw some color at it, then I can plumb it and see if it works.

 Thanks.

(6-29-2008 001.jpg)

(6-29-2008 002.jpg)

(6-29-2008 004.jpg)

(6-29-2008 006.jpg)

(6-29-2008 007.jpg)

(6-29-2008 008.jpg)

(6-29-2008 011.jpg)

(6-29-2008 015.jpg)

(6-29-2008 016.jpg)

(6-29-2008 020.jpg)

(6-29-2008 022.jpg)

6-29-2008 001.jpg (90KB - 452 downloads)

6-29-2008 002.jpg (88KB - 456 downloads)

6-29-2008 004.jpg (90KB - 409 downloads)

6-29-2008 006.jpg (96KB - 400 downloads)

6-29-2008 007.jpg (94KB - 387 downloads)

6-29-2008 008.jpg (105KB - 413 downloads)

6-29-2008 011.jpg (101KB - 432 downloads)

6-29-2008 015.jpg (90KB - 413 downloads)

6-29-2008 016.jpg (88KB - 458 downloads)

6-29-2008 020.jpg (97KB - 420 downloads)

6-29-2008 022.jpg (89KB - 433 downloads)