|
Washington Co Ks | I weld two old disk blades on a pipe the size to fit on my post hole digger in place of the bit. Cut the pipe to fit between the three point arms to unroll the wire next time. Leave more pipe on the bottem end to drill into the ground and hold the the bottom. I leave an insulator on the far end so I know if I have all the wire or if it broke and I have to find the end and set up again. To unroll I put the spool between the three point arms, tie the wire to a corner and drive to the next one. Watch how much wire you wind on a spool as it can get heavy. It's not fancy but it works fine and is cheep. | |
|
winding up hot wire after your done?
