|
western iowa,by Denison | Don't have a bender so we came up with the double plate,Ben,if you look close you can see a plate that is 1/2 way down,we run a 5x6 1/2 angle between the plates on the bottom,wouldn't need the inside brace,but no one believed me so we add it in-the 1st scraper doesn't have it-never will-on the yellow scraper Adam has a a-frame back brace-the 6x6-1/2 inch tube goes 3 ft past the box in the back-well theres 3 tubes in the center-6x6-1/2 tube-with the way we make the hitch the scraper's usually boil over with dirt,have tried some other companys that won't get 1/2 full in the same condtions-we use the yellow one to grade for buildings-normally a 30 minute job on a 75x150 pad because we can tilt for and aft and side to side-the front cylinder really makes that a easy job! | |
|
scraper pictures for Joshua
