|
NE IA | Finally got some time to post a pic of the tool I use to cut twine twine and net wrap off the rotor on my processor every couple weeks. Makes it alot easier and faster than any other method I've tried.Just hold down twine with hand and cut along till the end where I still use a utility blade to finish. Without the guard it will wrap and stop your grinder.
 (twinecutter1.jpg)
 (twinecutter2.jpg)
 (baleprocessor.jpg)
Attachments
----------------
 twinecutter1.jpg (47KB - 644 downloads)
twinecutter2.jpg (38KB - 645 downloads)
baleprocessor.jpg (48KB - 621 downloads)
| |
|
bale processor twine removal
