|
Kendall County, IL | I have voltage on 3 pin connector for flow meter, 5 volts at 10 o'clock and 6 o'clock using ground from 2 o'clock. I installed a new flowmeter and still nothing. If the meter cal on the tag is "1450 gal" and "meter cal is pulses per 10 units of measured volume", starting calibration value should be 145, right? This is a 60p flow meter.
With a jumper wire and meter cal at 1 field volume increases as it should. Bad new flow meter? Is there an ohm test for this flow meter?
Edited by ILSODGRWR 4/25/2024 09:11
| |
|
Raven console cable pinout - no voltage to flowmeter TEDBEAR!
