| Farms With CASE - 4/18/2024 06:38
Being daisy chained when a sensor fails or more likely has a pinched/grounded wire it shows as failed and some or all of them after it. So you need to check over the harness and sensor wiring very closely. You also need a known good sensor and plug it in in each position and see if that cures the issue. I believe after plugging in a new sensor you need to "reset planter" in the display.
Thanks,
Found the bad sensor, sensors seem to be working great now.
PTO pump blew a seal today so onto the next problem. |
case 1200 16/31 new to me- seed tube sensors not reading
