|
| I am new to making boundaries for our fields so I have some questions
1. When setting up circuits around the field will my planter automatically shut off when I cross from the infill pattern into the headland ( my planter runs off my gfx 750 and have trimble clutches) If so can this be turned on or off to where it would only shut my clutches off when it goes over what has already been planted?
2. I noticed when mapping while making my corners I would pause and make the corners square, the out side boundary would be squared but the inside would be curved, is there a way to make the inside corners square?
3. Is there a computer program/system/website, what ever it might be to where after I get done maping that I can go in to and clean a few things up instead of redoing the field?
4. When running a straight side I would pause the recording tell I got close to the other end and would resume, some times I would forget to resume soon enough, is there a way to just redo the line I messed up vs having to redo the entire field?
5.any other tips or tricks you have come across that made this easier?
Thanks greatly appreciated | |
|