|
Southern Illinois | Too be a bit more specific, on the center boom, near the accuboom node, there is a left and right boom valve connector. The accuboom node plugs into the harness ends going out to each side. You plug your boom outputs from your agleader in there instead. The AIM boom modules will get the section on or off right from there and it still controls the ball valves also.
Going into the AIM pressure module you will need to unplug the factory rate signal wires and connect your agleader rate control there. You will then just need to connect the agleader to the flowmeter. | |
|
|
3230 sprayer, AgLeader, AIM, and boom height control
