|
| I use Watts XF 3/4 inch. The water is plumbed through the side of the 12" pipe with a bulkhead fitting (below the concrete), then a 90 deg elbow, a ball valve, into the float assembley. I like the Jobe valve also, its quite similar. I have been using the 12" SDR pipe that has a bell end. I have started cutting the 12" a few inches above the concrete, and then putting the bell end on, to a height a few inches above the top of the tire. By using the bell end in the tank, I can remove it to access the float assembly if I need to in the future. | |
|
Cows and water
