|
Central IL | John, thanks for the reply.
I did try quite a few different profiles just to try stuff but the one I focused on that I know is correct is the CIHAG MidrangeMag 180_220 T4B.vdb for powershift. TAP Ei3 was set to 9 in that profile which means the profile had a pressure transducer (I tried 23 which is for flow sensor but didnt work either).
I specifically asked if it had an encoder possibly and was told that it would either be a flow switch or pressure transducer.
So assuming that you are correct (which I think is true) and that it does have an encoder, but the profile is set for a pressure transducer, do you know of TAP to change to make it want to see a quad encoder? | |
|
CIH Magnum 200 Pressure Transducer
