AgTalk Home
AgTalk Home
Search Forums | Classifieds | Skins | Language
You are logged in as a guest. ( logon | register )

Hagie sprayer with in command 1200 section control question
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
4WD
Posted 6/21/2022 13:50 (#9715027 - in reply to #9714956)
Subject: RE: Hagie sprayer with in command 1200 section control question


NE part of SW Iowa

On your 2nd question; you "could" set your speed to manual (say 5 MPH) then with water in booms(testing), turn on all booms and set pressure to 15 PSI, then read what the monitor is recording for GPM = put that number into your Minimum flow rate "spec" (might be something like 6.5 GPM or more)



Note: My booms are only 65 feet, so my number, may seem low, to a guy with bigger booms.



Edit: Don't forget to "reset" your speed, back to "GPS speed" when done, with this test (at that 5 MPH setting) = I think the monitors, now even have a RED blinking light, that says "Manual" in the upper right hand area, IF you are still set to a manual MPH speed

 



Edited by 4WD 6/21/2022 14:02
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)