|
swmn | Not sure about the remote output issue but I want to make sure you realize that when running Trimble Autopilot, GPS is output as if the antenna is directly above the control point of the tractor you are using to pull the planter. On a mfwd tractor, the control point is the rear axle. On an articulated, it's the front axle. When entering measurements into the 2020, make sure you don't enter any offsets until it asks for the distance from axle to hitch and back. Axle to GPS receiver should be set to zero on the 2020. That measurement is accounted for on the Trimble side and if it is entered into the 2020 as well it will cause your offset to be wrong. | |
|