|
| I have a Case IH sprayer that has AIM command pro. It has 6 boom sections with 9 nozzles in each section.
I want to reconfigure the boom sections, which would result in moving 3 nozzles from outer section to the next innersection. (change the wing to be 3 nozzles on sec 1 and 12 on sec 2 vs having 9 and 9). Anyway, for the Aim Pro, do I have to have a VCM for each "hard" boom section? In the AIM command pro manual (and also the PinpointII manual), it says that I can assign nozzles from one VCM to another....but they don't ever tell me exactly how to do it.
If I want to move NCVs 4, 5, 6 from section 1 to section 2, do I set the Aux boom as 1 and the soft boom as 2? or, is it the other way around?
So, if this is not possible, then my question is can I have a VCM that has only 3 nozzles? Do I have to buy an additional VCM for the section that has 12 nozzles?
Edited by chris dds 5/23/2022 09:39
 (VCM (full).jpg)
Attachments
----------------
 VCM (full).jpg (77KB - 159 downloads)
| |
|
Capstan/Aim Command VCMs
