Have two old toolbar's I'm going to put together to make one anhydrous applicator.  Have some of the yetter rolling cutters that have the hardware on them to mount an anhy, shank.  They are the ones that swivel.  Was just going to use theses as a rolling cutter and mount a coil tine shank on the bar also.  Would be able to get better trash clearance out of the bar if I would use the shank that mounts to the coulter, but they would swivel instead of being stationary.  Any one used them this way,  look to be kind of clumsy, never have used a toolbar that had knives that swiveled with the rolling cutter. Thanks for any ideas.

Eric