|
Ontario, Canada | A few years ago I clipped a windmill with the unloading auger and bent the rod in the cylinder. Took the cylinder to a hydraulic shop, they put a new rod in and it worked fine. Then part way through last year when I put the auger out it would get about half way and then slow down like it was hard to move but would still go all the way out. Finally it would only go half way so got a new (overpriced) cylinder from Case and now it goes all the way again but still gets stiff half way out. The swival collar is heavily greased so that's not the problem. What could be causing this? | |
|
2144 unloading auger
