|
Ohio | the foamer gets most of its action at the end of your nozzle at the tip and not directly at the canister, due to the air pump meeting the water mix there, so the easiest thing to do is add your water then add your foaming agent, dye, etc. If you lose some foam at the top of the can it should be miniscule compared what is in the can. Remember the ratio of the foaming agents?....It doesnt take a whole lot to make a lot of foam a little goes a long way, and that stuff is pretty cheap. If you are getting a huge volume of foam when you add water try not to aggitate the solution so much...hope this helps explain this a little better | |
|
Stupid foamer ?
