|
Eastern Washington | On my 535, I made my own (with cable).. I welded a clevis (pin down) to a piece of steel that is bolted to the front diff. I then used a big clevis and connected the cabled to the front of where the drawbar connects under the tractor, put the cable up thru the one I welded to the steel plate, and then attached the front loop to the front of the tractor (near where the toolboxes are)... had to put a cable clamp on the cable, on the front side of the clevis at the front axle, so that the cable doesn’t get too slack... was way cheaper then buying from cased... used it a few times. | |
|
STX 440 DRAWBAR & TOW PKG
