|
| From the settings that you have posted your Turn Angle is 100 that should be lowered quite a bit. The default is usually 20 degrees on the Turn Angle. I would start with my turn angle at 20 and see how the unit responds if it is slow and sluggish along the AB line you can take the turn angle down from there. If it is fast and jerky you will have to bring the turn angle up from 20. Are you sure that your Turn Angle was 100 and that wasn’t your online aggressiveness?
Were you able to us the calibration wizard that was located on the Ez-guide 500? This would be located under the wrench on the right side, then under the advanced user mode then go to Autosteer then to Ez-steup then to Ez-steer Calibration Wizard.
| |
|
EZ Steer 500
