|
Spink County, SD | Torn,
I get that feeling, too. (That i am one of the first) I was unable to seed any beans today, but did get a chance to look at things a little closer. It appears that part of the problem (the alarm going off when I had the meter switch off, or the prescription at 0 lb/ac, is due to an incorrect setting in the Flow Monitoring side on the VT. The meters Shoots were incorrectly matched to their respective meters. At least that makes sense until I can field verify this.
As for the erratic loss of communication, I think that the problem might be in a faulty connector. Where the flow ECU connects to the main wire harness, I found that the middle pin in that connector was pushed back into the connector - hope it is that easy to fix, although i was unable to "wiggle" and cause the monitor to lose communication....
| |
|