|
East Prairie, MO | I haven't had time to mess with boundaries, just been spraying! One problem I've seen that can be had, and it goes along the same lines as the angled ditch, is that when you turn on the end and your boom momentarily sticks out of the endrow pass that last section will kick on for a sec and lower your pump pressure therefore causing a low pressure startup when crossing the line to go back through the field. When I know I'm in a situation like this I let insight turn them off, tap my foot switch while turning, then just kick it back on after I'm past the problem point and let insight take back over. I'm sure I will wish I had taken the time to put boudaries in but I just haven't had time to do it right, plus I've realized that I have some fields that are side by side that I spray as one field in real life but in the insight they are separate and that has posed a problem. So I've just been spraying both under the same field map for now.
Edited by semosandfarmer 5/13/2008 21:26
| |
|