|
| I bought one at Farmfest a couple of years ago from a place in Texas. Smaller Mom and Pop shop I think. It bends a lot more things than I have had time to learn but a guy does mostly mall stuff anyway. It sure saves on bending small things for fab or drop rods for gates It was around $250.00 or so. That was with a set of round dies. They show you how to make dies which isn't real hard and they're the expensive part. Should be able to find them on goggle This one is well made made and will bend rod probably up to 3/4 or so on shorter bends and 5/16 x 1 or so on short bends. If you wanted to bend some thing a little bigger you should be able to preheat it then bend. | |
|
Small iron benders
