|
| If you use an EZ Guide 500 display the calibration wizard will help you with the initial settings. You would only need a bracket that fits your steering column.
Also this steering delay setting may help performance on this type of equipment.
Steering delay
When you configure the EZ-Steer 500 system on a swather or sprayer,
the Sprayer steering delay and Swather steering delay settings are
available on the Vehicle Setup screen:
Some swathers and sprayers have steering that is slow to react after the
steering wheel is turned.
The EZ-Steer 500 system uses the steering delay setting to compensate
for this slowness and ensure that steering corrections occur at the
correct point.
To access the Vehicle Setup screen, select Configuration / Auto Steer /
EZ-Steer Setup / Vehicle Setup.
B Tip – To improve the performance of your swather, try adjusting the
Swather steering delay setting. Only adjust the setting by a small amount
(0.1 seconds) at a time. Test the result between each adjustment.
http://trl.trimble.com/docushare/dsweb/Get/Document-378360/EZ-Guide...
Edited by GPSNUT 1/31/2008 14:12
| |
|
EZ-Steer In a NH 340 Windrower...
