|
Dagmar, MT | Thanks for the help. I got time to mess around some more today and did what you suggested. Steering angle adjusted to 13 from 15 and freeplay lowered from .5 to .3. This seemed to help. We're not actually cutting yet just trying to get ez-steer close before we start.
We're using EZ + and still running 3.10 for software. It was working so good in tractors(9520T & 7820), I didn't figure getting updates could help much. Very rare to be more than 2" off in either tractor. I'll post back with vehicle setup settings when I'm satisfied with performance. | |
|