|
South Australia | No not yet, although my information is that if you are no using ez-boom then to continue using 1.01. Just a question on the adaptive curve on the ez-guide 500, today i used it to go around a small rectangular piece with curvy scrub lines either side. My intention was to spray it "round and round," but the guide line became stuck on the outside of the piece.
I also had this problem using headlands, i drove inside the headlands and it locked onto the ab line, then when i drove back to continue my headland and the ez-guide would not pick up the line until i restarted the unit. Is there another way of getting the 500 to change the line it is locked onto, on the rinex and zynx systems you would press guidelock until it picked up the line you want.
Ideas?
Thanks
waterbottle | |
|