|
Eastern Iowa | We have recently gotten our Trimble 252 back after sending it back to Ag Leader for a hardware and software recall. After getting it, I see that the receiver has been set back to its default configuration. Last spring I used Ag Remote to reconfigure the 252 to run the Insight on the A? channel and the EZ-Steer setup off the B? channel. This spring the EZ-Steer is being replaced by the Trimble Autopilot system. So do I need to run one channel of the 252 to the Insight and is the other channel of the 252 used to run the Autopilot system? I'm not quite sure how the Autopilot ties into the system as it hasn't been installed on the tracotr yet. I know there are a few guys on here who are running the same setup that I will be this spring which is the 252, Autopilot, and Insight interface. Do any of you remember your 252 configuration details off hand? Just looking for some advice before diving into it tomorrow morning. | |
|
|
Agboy, Tedbear, and others... Trimble 252 receiver configuration
