|
| My air bags only air up when the fill solenoid can start the compressor. So if the there is over 140 psi in the compressor tank the airbags will not air up because the solenoid will not open. It is a John Deere active pneumatic block tied in with a 2020 compressor. I was thinking about putting a jumper wire on the compressor harness where it goes into the hydraulic block but not sure how things will work. Anyone have any experience on this issue.
Edited by Coolplanter 4/22/2024 22:56
(IMG_0782 (full).jpeg)
(IMG_0784 (full).jpeg)
(IMG_0780 (full).jpeg)
(IMG_0777 (full).jpeg)
Attachments ---------------- IMG_0782 (full).jpeg (147KB - 12 downloads) IMG_0784 (full).jpeg (159KB - 12 downloads) IMG_0780 (full).jpeg (135KB - 15 downloads) IMG_0777 (full).jpeg (138KB - 15 downloads)
| |
|