|
| What monitor does it have? That may not make much difference to start though.
As 1666 said, try replacing the AutoSense cable. It's the gray cable connected between a 4 pin Deutsch and the round plug on the small AutoSense box on your front axle. Left side I think. Common failure point with CNH equipment.
2nd, you could try to re calibrate all the sensors from the monitor.
3rd, your NAV gimbals could be stuck. AgExpress can repair those, but my luck with repair on NAVs is hit and miss.
Edited by GcDm2010 2/10/2024 14:01
| |
|